Samsung HG32EE590 Installation Manual page 25

Hotel TV Function
Category Item
REACH
REACH IP Mode
Server IP Setting
REACH Channel
REACH Update
REACH
Time
Solution
REACH Update
Immediate
Group ID
Room Number
REACH Config
Version
Network Setup
Network
SmartHub Model
Setting
SmartHub Setting
Service Discovery
Initial value
• ON: The feature of REACH in this TV becomes available.
OFF
• OFF: The feature of REACH in this TV becomes not available.
... If enabled, Reach will work over IP instead of RF.
... The URL of the Reach IP server, for example https:\\192.168.1.2:443.
Assign a DTV channel number to carry the update REACH data. This channel
...
number must be the same as the number set on the Reach server.
Lets you set when data such as updated SW, cloning files, and S-LYNC REACH
contents is downloaded from the REACH server to the TV :
1hour: Every hour
2hour: Every 2 hours
...
12:00 AM: every 12:00 a.m.
2:00 AM: every 2:00 a.m.
12:00 PM: every 12:00 p.m.
2:00 PM: every 2:00 p.m.
• ON: Whenever the TV enters standby mode (the power cord is plugged in and
the power is off), the REACH data is updated on the TV.
...
• OFF: The REACH data is only updated on the TV at the REACH server update
time.
Select the Group ID of the REACH server. (Refer to the REACH server manual for
...
more details.)
... Set the Room Number.
... The version of REACH is displayed.
Set an IP address to establish an Internet connection.
Soft AP: Using this function, you can connect the TV on your mobile devices. Set
the options for connection of Wi-Fi device.
• Soft AP: Turns on or off the Soft AP. When Soft AP is set to On, your mobile
devices can find the TV name in Wi-Fi connection list.
• Security key: Set a security key that you need to enter on other devices so they
can connect to the TV.
‒ Input the generated security key into the device you want to connect.
‒ If network does not operate normally,check the security key again. An
incorrect security key may cause a malfunction.
✎ Soft AP may not be available if it is not supported by the model.
✎ Maximum number of devices that can be connected: 4 devices.
✎ Bitrate : 10 Mbps/device.
✎ The specifications above are based on our in-house testing. Actual
performance may vary depending on your wired/wireless network
environment.
Set Smart Hub Model.
Set up Smart Hub.
If this option is set to On, you can share content with other devices, such as
On
smartphones, in DLNA mode.
Description
25
English