Technical Data - Whirlpool 6ADP 5656 WHM Service Manual

08.08.2002 / Page 2
Doc. No: 4812 718 18231

Technical data

Dimension
Height
Width
Depth
Weight
Electronic boards
Service boards
Serial boards
DUB
Programing of version and programmed control
board, see „Service" and „Data set" on rating
plate of inner door:
CB programmed
Data set
Basic control board, not programmed see on the
board itself
Succession of programs
Programs
Succession A1a - A3a - A4a - A5b - A6a - A7a
Alarms
Refill rinse aid
Options
Zone washing
Delay function
Program information
Start indicator
Pre wash
Main wash
Drying
End
All programs will be locked after start. Changing
the program or finishing the program will be
possible only after pressing the start button for
longer then 1.5 sec. (Break by customer)
A switching off the appliance or unplug the
appliance for a while, this will frozen the program
step and later on, the program continuos on the
same position.
Exception: Switching off the appliance or unplug
the appliance during the drying phase, this will lead
directly to the end of the program.
6ADP 5656 WHM
8542 656 53710
85.0 cm
59.7 cm
61.0 cm
58 kg
see spare part list
see on the boards itself
4619 724 06781
464783
464771
4619 724 17411
see program diagram
Whirlpool Europe
Customer Service
Water Volume at alternating spray system
Volume at alternating spray system (same level
when selected zone washing as in the normal
programs)
Water
Regeneration
Back rinse 3x
Prewash
Main wash
Intermediate rinse 1
Intermediate rinse 2
Clear rinse
Safety/ overflow
Measuring the level
Remove the coarse sieve, put in a measuring
meter into the sump, measure the hight of the
water level.
Detergent max.
Pre-wash
Main-wash
Rinse aid
6 Dosage steps
Water pressure
Inlet pressure
Spray pump pressure
Rotations
Spray pump motor
Drain pump motor
Spray arm lower
Spray arm upper
Spray arms, turning rhythm at alternating spray
system
Turning starts every time with the upper spray arm
Pre wash Lower arm ~3min, Upper arm ~1min
Main wash Lower arm ~3min, Upper arm ~5min
Intermediate rinse
Lower arm ~2min, Upper arm ~2min
Final rinse Lower arm ~2min, Upper arm ~2min
Service Test program
Lower arm ~30sec, Upper arm ~30sec
Remark: When switching of the main switch or
interrupt the mains during the Test Program runs,
then the alternating of the spray arms change in
the test program to the rhythm of main wash 5/3
min.
S E R V I C E
Volume Level
0.3 l 15 mm
1.0 l 60 mm
3.9 l 120 mm
3.2 l 118 mm
3.2 l 118 mm
3.2 l 118 mm
3.2 l 118 mm
8.5 l 141 mm
3
10 cm
3
40 cm
3
135 cm
1 - 6 ml
0.3 - 10 bar
0.3 bar
2800 RPM
3000 RPM
30 - 40 RPM
30 - 40 RPM