Setup - JVC LT32DP8BG User Manual

Customising your TV

Setup

Setup
Setup
Navigate
Digital Audio
Output
PCM
Dolby Digital : The Dolby digital signal is output when the Dolby Digital signal is received
Please read ""Dolby Digital" output from the DIGITAL AUDIO OUT terminal" (P. 23) before setting.
Banner Duration
Receiver Upgrade
The TV will automatically search for new tuner software and run the reception test (for digital
channels) at midnight (3 AM) on a daily basis. You can select the desired operation with this
setting.
The Receiver Upgrade function works only when the TV is off (standby).
If new software is available, the TV will automatically download and upgrade the tuner software.
If the TV detects channels that became receivable or if the TV was not able to receive a certain channel,
a message about updating the PR List will be displayed when the TV is turned on.
"Updating the PR List" (P. 22)
g
Auto
Manual
16
14:00 05/05/2007
Digital Audio Output
Banner Duration
Receiver Upgrade
Common Interface No CI Module
Antenna Power
Select MENU Exit
Output the digital signal from the DIGITAL AUDIO OUT terminal.
: The Linear PCM signal is output
Select the display time for channel information
(2 sec / 5 sec / 8 sec)
: The search for new software and the reception test will operate at midnight. In
addition, the TV will start searching for new software whenever the TV is
turned off. Normally set to "Auto".
: Only the search for new software will operate at midnight. The reception test
will not be run. In addition, you can start searching for new software whenever
you want.
To start searching, select "Manual" and press "OK" button.
Software Version
0.31.01
OK Search for new
Select "Search for new" and press "OK" button. Then, follow the instructions
on the screen.
In standby: Upgrade the software automatically when the TV is turned off.
PCM
2 sec
Auto
Off