Pro-Link 9000 Diagnostic Data Reader Information - Allison MD 3060 Troubleshooting Manual

W T E C I I E L E C T RO N I C C O N T RO L S T RO U B L E S H O OT I N G M A N UA L
APPENDIX N — PRO-LINK
This appendix is to assist the technician in the use of the Pro-Link
troubleshooting manual. For complete information on the Pro-Link
®
with each Pro-Link 9000 (MPSI Manual No. 907005 and SW3085EN Pro-Link
A. Preparing to Use the Pro-Link
1. Connect the vehicle cable from the Pro-Link
Allison Transmission wiring harness. Refer to the vehicle manufacturer's manual for location of
the connector.
2. Be sure that the vehicle ignition key is on. Check to see that the Pro-Link
energized. If power is not being supplied, turn off the vehicle ignition and recheck all cable
connections.
3. Turn on ignition key and if power was still not supplied, turn off the ignition key and check the
Pro-Link
the edgeboard using a soft cloth. Check the 2-amp fuse located in the cartridge. Replace the fuse, if
necessary.
CAUTION: Never use anything but a 2-amp fuse for replacement.
4. Review the KEYPAD section of the Pro-Link
5. Refer to Figure N–1 for a graphic representation of the Pro-Link
INFORMATION
®
9000 Diagnostic Data Reader
®
9000 cartridge installation. Carefully remove grease, oil, or other contaminants from
Copyright © 1998 General Motors Corp.
®
9000 DIAGNOSTIC DATA READER
®
9000 functions that are mentioned in this
®
9000, consult the manual that is furnished
®
9000 to the diagnostic data reader connector on the
®
9000 Manual.
®
Student Workbook).
®
9000 has been
®
9000 menu selections.
N–1