Triumph Tiger 1050 2008 Owner's Handbook Manual page 85

Rebound Damping Adjustment
ceda
1. Rebound damping adjuster
The rebound damping adjuster is located at
the bottom of the rear suspension unit on the
left hand side of the motorcycle.
To adjust the rebound damping setting,
rotate the adjuster clockwise to increase
rebound damping and counter-clockwise to
decrease. Always count the number of turns
back from the fully clockwise (maximum)
position.
Note:
• The motorcycle is delivered from
the factory with the rebound
adjuster set at one turn back from
maximum.
Maintenance and Adjustment
Spring Pre-Load Adjustment
1
ceda
1. Spring pre-load adjuster
The spring pre-load adjuster is situated on
the right hand side of the motorcycle, at the
top of the rear suspension unit.
To adjust the spring pre-load setting rotate
the slotted adjuster clockwise to increase, or
counter-clockwise to decrease.
Note:
• The settings are measured by the
number of adjuster 'clicks' out
from the fully screwed in position.
• The motorcycle is delivered from
the
pre-load set to 16 'clicks' back
from the fully screwed in position.
1
factory with the spring
85