Peakeep MHP3132 Instructions

Instructions
MHP3132

Getting Started

1. Remove the battery compartment cover from the bottom of the unit, properly align and insert 2 AAA alkaline batteries,
replace cover.
2. Uncoil the antenna and extend to its full length.
3. Plug the unit into an AC power outlet. The factory default time of 12:00 AM displays.
Note:
Backup batteries maintain time, alarm, and radio station pre-sets; however they do not power the display, nor trigger the alarm
during power interruptions. For best results, replace batteries every 6 months.
Set Time
1. With the radio off, press and hold the Time button until the time display starts to blink, then release Time button.
2. Set the unit to the current time using the Hr (Hour) and the Min (Minute) buttons while time display is blinking.
3. When the current time is displayed, press the Time button to confirm. The display will stop blinking.
Note:
When the time display starts to blink, the seconds' timer re-sets to zero. If no buttons are pushed within 4 seconds, the unit
will revert to previous settings. When setting current time, be careful to select AM or PM, as appropriate, by monitoring the
PM indicator light.
Set Alarm
1. With the radio off, press and hold AL1 (ALARM 1) button until alarm time starts to blink, then release AL1 (ALARM 1) button.
2. Set Alarm 1 time using the Hr (Hour) and the Min (Minute) buttons while alarm time is blinking.
3. When the desired Alarm 1 time is displayed, press the AL 1 (ALARM 1) button to confirm.
4. For Alarm 2, repeat the remainder of steps 1, 2, 3 with AL 2 (ALARM 2) button.
Note:
When setting alarm times, be careful to select AM or PM, as appropriate, by monitoring the PM indicator light. If no buttons are
pushed within 4 seconds, the unit will revert to previous settings.
Turn Alarm On
With the radio off, press AL1 repeatedly to toggle between Buzzer and Radio alarm modes, as indicated by the buzzer alarm
indicator or radio alarm indicator lights.
Disable/Cancel Alarm Function
With the radio off, press AL1 or AL2 buttons, as appropriate, until both the buzzer and radio alarm indicators are off.
Wake to Alarm
When the alarm sounds, the appropriate alarm indicator blinks. The buzzer alarm sounds at average volume. The radio alarm
plays the most recently tuned station at the selected volume. Both alarm options sound for up to 1 hour.
Turn Alarm Off
1. Press the Snooze/Sleep button to temporarily suspend the alarm for 9 minutes.
2. To turn off the alarm, press On/Off button to re-set the alarm for the next day.

Listening to the Radio

Turning Radio On
Press ON/OFF to turn on the radio and toggle between AM and FM bands.
Auto station search and manual presets
With the radio on, press and hold the T+ (Tune +) or the T- (Tune -) buttons. The unit will automatically locate the first strong
station. When a desired station is found, press and hold the M+ button, "P01" will blink on the display. Press the M+ button to