Monitor - Sony MEX-DV2000 Operating Instructions Manual

Getting Started
Installing the unit and an
optional monitor
Firstly, install and connect the unit and an
optional monitor.
This unit can be operated using the displays that
appear on the unit and/or the optional monitor.
Note that this manual includes instructions
concerning displays on both unit and/or optional

monitor.

Unit
For details, see the supplied installation/
connections manual.
Note
Be sure to install the optional monitor safely, and in a
place where it does not obstruct the driver's view.
Resetting the unit
Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel (page 13) and press the
RESET button with a pointed object, such as a
ball-point pen.
RESET
button
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
12
Optional monitors
Performing initial setup
OFF SOURCE
Volume control dial
After resetting, the display for initial speaker
setup appears.
Be sure to set correctly following the procedure
below to enjoy the various sound functions of
this unit.
To skip the initial setup, press (OFF)/
(SOURCE), or insert a disc.
Note
The initial setup display automatically disappears if no
operation is performed for 30 seconds.
During setup procedure, it is canceled if no operation
is performed for 15 seconds.
1
Press the volume control dial in the
initial setup display.
2
Rotate the volume control dial to set
the center speaker connection status,
then press it.
Select "C ON" if the center speaker is
connected, or select "C OFF" if not.
3
Rotate the volume control dial to set
the subwoofer connection status, then
press it.
Select "SW ON" if the subwoofer is
connected, or select "SW OFF" if not.