Advertisement
4.
Install
1.
Pass the Keypad wires through the center hole in the
prepared mounting surface.
2.
Attach the assembled Bluetooth Keypad 27213 and
Weather Cover 27211 using (4) #10-24 x 1/2" Long
Button Head Screws.
5.
Connect
Follow the keypad wiring chart to connect the Keypad cable to
the keypad terminal connector provided with the Door
Controller.
1.
Loosen the terminal screws on the connector
2.
Insert stripped and prepared wire ends. Make sure the
wire pairs remain together in their correct sequence.
3.
Tighten the terminal screws, ensuring the wires are firmly
engaged
NOTE: The Keypad cable can be extended using 22AWG
twisted pair wire to a maximum total length of 50 feet using a
splicing method appropriate for your installation.
For more information about making connections, review the
Door Controller Installation and User Manual
Master Lock Company LLC, Milwaukee, WI 53154 U.S.A. | 800-574-7260
©2017 Master Lock Company LLC | All Rights Reserved.
Activating the Keypad
Wire Color
Black
White/Black White
Red
White/Red White
Brown
White/Brown White
Orange
White/Orange White
Battery Board Switch are OFF before connecting or
disconnecting devices to the Controller. Failure to
observe this precaution may cause damage.
Configuration
9
Keypad Wiring Chart
Terminal Position
BK
WE
RD
WE
BN
WE
OE
WE
Warning!
Ensure Power Source and Door Controller
P57672
Signal Name
Ground GND
V+ 3VDC
Battery Jump
Tamper input
TX +
TX-
RX+
RX-
REV A
Advertisement
