Weslo CADENCE DX5 User Manual page 8

DIAGRAM OF THE CONSOLE
CAUTION:
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) while operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.) In addition,
make sure that batteries are installed in the console.
(See step 6 on page 6.) If there is a thin sheet of clear
plastic on the console, remove it.
Step onto the foot rails of the treadmill. Next, find the
clip attached to the key (see the drawing above). Slide
the clip onto the waistband of your clothes.
Speed Control
Key
Before operating the
Monitor Display
Follow the steps below to operate the console.
Insert the key fully into the power switch.
1
Note: Inserting the key
will not turn on the dis-
play. The display will
turn on when the
on/reset button is
pressed or when the
walking belt is started.
If you just installed bat-
teries, the display will already be on.
Reset the console and start the walking belt.
2
Turn the speed control
all of the way to the
Reset position. Note:
Each time the walk-
ing belt is stopped,
the speed control
must be turned to the
Reset position before
the walking belt can be restarted.
Next, slowly turn the speed control until the walk-
ing belt begins to move at slow speed. Carefully
step onto the walking belt and begin exercising.
Change the speed of the walking belt as desired
by turning the speed control.
To stop the walking belt, step onto the foot rails
and turn the speed control to the Reset position.
8
Clip