Weslo CADENCE DX5 User Manual page 6

3. Place the Console Base (45) in the position shown.
Insert four Handrail Bolts (68) through the Console
Base and the Uprights (37). The Handrail Bolts
must be inserted from the inside as shown.
Attach a Handrail Washer (41) and a Handrail Nut
(77) to each Handrail Bolt.
Tighten all four Handrail Bolts (68) as tightly as
possible. Carefully lift up and push down on the
handrails to make sure that the Console Base
(45) does not move. Regularly inspect and tight-
en all four Handrail Bolts.
4. Attach the Frame Guide (66) to the left side of the
Frame (21) with two Frame Guide Screws (40) as
shown. Note: Be careful not to overtighten the
Screws. Make sure that the thick end of the
Frame Guide is at the bottom.
5. Remove the backing from the Adhesive Clip (2).
Press the Adhesive Clip onto the base of the Upright
(37) in the indicated location. Press the Allen
Wrench (35) into the Adhesive Clip.
6. The Console (49) requires two "AA" batteries (not
included); alkaline batteries are recommended.
Open the Battery Cover (48) as shown. Press two
batteries into the battery compartment, with the neg-
ative (—) ends of the batteries touching the springs.
Close the Battery Cover.
7. Make sure that all parts are properly tightened
before you use the treadmill. The use of the remain-
ing parts will be described in other sections of this
manual. To protect the floor or carpet from dam-
age, place a mat under the treadmill.
3
77
41
Handrails
68
4
40
66
Thick end
5
6
Batteries
6
45
68
37
45
68
21
37
2
35
49
48
77
41