Programming Additional Transmitters - DaimlerChrysler Jeep Manual

The "Flash Lights On Lock/Unlock" feature can be
reactivated by repeating this procedure.

Programming Additional Transmitters

Vehicles will be shipped from the assembly plants with
two key fob transmitters programmed only for that
vehicle. A total of eight fobs can be programmed for your
vehicle. Additional fobs can be programmed to your
vehicle through the use of a currently programmed fob.
NOTE: When entering program mode using that fob, all
other programmed fobs will be erased and you will have
to reprogram them for your vehicle.
Use the Following procedure to program additional key
fobs if the vehicle is not equipped with Sentry Key:
1. Enter your vehicle and close all doors.
2. Fasten your seat belt (Fastening the seatbelt will cancel
any chiming that may confuse you during this program-
ming procedure).
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 23
3. Place the key into the ignition.
4. Turn the ignition to the ON position ( Do not start the
engine ).
5. Press and hold the "Unlock" button on the key fob.
6. After holding the "Unlock" button for four seconds,
also press the PANIC button within 6 seconds.
7. When a single chime is heard release both buttons. The
chime is an indication that you have successfully entered
program mode. All fobs that are to be programmed must
be done so within 60 seconds of when the chime was
heard.
8. Using the fob to be programmed, press and release
both the "Lock" and "Unlock" buttons, simultaneously.
9. A single chime will be heard.
10. Within four seconds of hearing the chime, press and
release the "Unlock" button on the fob.
2