Table of Contents
Advertisement
To Set At A Desired Speed
When the vehicle has reached the desired speed, press
down on the lever and release. Release the accelerator
and the vehicle will operate at the selected speed.
NOTE: The vehicle should be traveling at a steady
speed and on level ground before pressing the SET lever.
To Deactivate
A soft tap on the brake pedal, pulling the speed control
lever towards you "CANCEL", or normal brake or clutch
pressure while slowing the vehicle will deactivate speed
control without erasing the set speed memory. Pressing
the ON/OFF button or turning off the ignition switch
erases the set speed memory.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 105
To Resume Speed
To resume a previously set speed, push the "RESUME
ACCEL" lever up and release. Resume can be used at any
speed above 20 mph (32 km/h).
To Vary The Speed Setting
When the speed control is ON, speed can be increased by
pushing up and holding "RESUME ACCEL". Release the
lever when the desired speed is reached, and the new
speed will be set.
Tapping "RESUME ACCEL" once will result in a 2 mph
(3 km/h) speed increase. Each time the lever is tapped,
speed increases so that tapping the lever three times will
increase speed by 6 mph (10 km/h), etc.
3
Advertisement
Table of Contents
