DaimlerChrysler Jeep Manual page 209

Table of Contents

Advertisement

up on the accelerator and apply as little throttle as
possible. Be sure to adapt your speed and driving to the
prevailing road conditions. The "ESP/TCS Indicator
Light" will flash any time the ESP or TCS is active and
helping to improve vehicle stability. If the "ESP/TCS
Indicator Light" is on solid, the ESP system has been
turned off by the driver or a temporary condition exists
that will not allow full ESP function.
27. O/D (Overdrive) Off Indicator Light
This light will illuminate when the O/D OFF
button has been selected. The O/D OFF button is
located on the gear shift lever.
28. Sway Bar Indicator Light — If Equipped
This light will illuminate when the front sway
bar is disconnected.
UNDERSTANDING YOUR INSTRUMENT PANEL 209
29. Electronic Stability Program (ESP) Warning
Light/Brake Assist System (BAS) Warning Light
The ESP/BAS warning light in the instrument
cluster comes on when the ignition switch is
turned to the "ON" position. The light should
go out with the engine running. If the ESP/
BAS warning light comes on continuously with the
engine running, a malfunction has been detected in either
the ESP or the BAS system. If this light stays illuminated,
have the ESP and BAS checked at your authorized dealer
as soon as possible. Refer to "Electronic Brake Control
System" in Section 5 for more information.
4

Advertisement

Table of Contents
loading

Table of Contents