Accessing The Thermostat Menu - Capitol Energy Systems TWC46 Operation Manual

Accessing the Thermostat Menu

The programming menu's on the thermostat will normally be locked to
prevent tampering since all of the programming should be done online
through the EMS. To access the thermostats programming menu's you
need to enter a code.
Hold down the number one button then enter the following sequence:
UP – UP – Down - Down – 2 - 4 – 2 - 4
Then release the number 1 button
The EMS sends a command to lock the programming screens to prevent
tampering. If you are unable to use the up and down arrows in the Menu
Selection Screen hold down the #2 and #3 buttons to launch the Installer
Settings Menu
Display Lock: Use the + and – button until you display the U (Unlock)
button to unlock the programming screens.
Initial Set-Up
Set Clock: The first screen you will see is to set the clock. You do not
need to set the time since the time will automatically be set once the
thermostat connects to the online EMS. Press the #1 back button to
access the next menu.
4:30
75
PM
Sys Off
64H
82C
Link Ok
AUTO
FAN
On
3
1 2
4
Installer Settings
Display Lock
Service Mode
Network Settings
System Settings
Done
UP
DOWN
U
Select
Page 6