Capitol Energy Systems TWC46 Operation Manual page 14

Type – Use the + and – buttons to choose Gas/ Elec or Heatpump
•
Fan Type – if HVAC type = Standard: Gas or Elect
•
OR
Changeover – if HVAC type = Heat Pump: Changeover with cool or
•
changeover with heat
nd
2 Stage Heat – Use the + and – button for Y (yes) or N (no)
•
nd
2 Stage Cool - Use the + and – button for Y (yes) or N (no)
•
Relay Info
Pres the #2 Status button on the Thermostat info screen to assess the
Relay States Screen. Here you will find the commands that the
thermostat is passing to the HVAC Unit.
WiFi Network Status
This screen displays all known network status parameters as shown
below:
Ad Hoc Mode
The Wi-Fi radio can also be placed into Ad Hoc mode which enables
Peer-to-Peer communication without a network router. ***This is the only
way to program the TW46 thermostat.
Enable Ad Hoc mode by pressing the "+" key at the appropriate
•
screen
This sets the Thermostat IP Address to: 192.168.0.1 and the Subnet
•
to: 255.255.255.0
Use your PC to connect to the thermostat and set the wifi settings.
•
Mechanical Settings
Type Gas/Ele
Fan Type Gas
nd
2 Stage Heat N
nd
2 Stage Cool N
+
Done
Relay States
W1: Off
W2: Off
Fan: On
Y1: Off
Y2: Off
Done Status Setup
WiFi Network Status
SSID: roving1 Chan: 10
Security: WPA2 DHCP: ON
IP: 192.168.1.100 : 2000
SUB: 255.255.255.0 Auth: Y
GW: 192.168.1.1 Assoc: Y
Done
Page 14