Turnstile Mounting Using The Swivel Support - Honeywell Tema-Voyager Compact Installation Manual

4
5
6
7
8
9

Turnstile mounting using the swivel support

The sequence is the same as the sequence for wall mounting, except that
the swivel ball shall be fixed to give the reader the opposite slope. See
"Mounting the reader on the wall mount" on page 14.
34 https://extranet.honeywell.com
If required, install the tamper switch into the appropriate guide.
Route the interface and power cables from the surface of the turnstile
to the reader. Leave about 5-6 cm of excess cable.
Arrange the cable so that the connectors are on the same side as their
sockets without crossing the cables.
Connect the cable to the 3.5mm Pitch Plugs and other connectors. Be
sure that there are no short circuits between the wires. Be sure to
connect the wires by paying attention to the correct position (shown in
Figure 6). (The screws must be on the side of the Ethernet connector.)
Use the bayonet fitting shown in
support.
Lock the reader onto the support with the 2x Torx screws.
Figure 7 to close the reader on the