Mounting the reader on the support
The Voyager device is composed of reader and support. The reader must
be installed on one of the following three supports:
• Wall mount
• Turnstile mount
• Swivel mount
You do not need to open the reader to install it on the support.
jumper (included in the toolkit).
Mounting the reader on the wall mount
Use this support to install the reader on a wall.
Inputs and DC power
RS-485 length settings
: If you do not use the tamper, close the P5 connector with the
Figure 2 Wall mount (front and back views)
6Pin,--3.5MM Pitch, Header connector
2Pin,--1.27MM DIP switches