Fingerprint T&A Access Control System User Guide
3. Installation
3.1 Fixing mounting plate
Take out a Access Control System
①
between machine body and mounting plate until it is out, see
figure (1).
Carefully take up the bottom of mounting plate, see figure (2),
②
push it up, see figure (3), then take away the mounting plate.
Determine the position of mounting plate on the wall. The
③
Access Control System should be mounted on the external wall of
the door approximately 1400mm from the ground to the unit
bottom. After the position is determined, you could drill a hole
(18mm*20mm) for cable out, see below figure shadowed part.
Make the hole of mounting plate meet the drilled hole on the
④
wall, Use the screw to fix it on the wall, (for the details please see
following figure)
after installation, please make sure the mounting plate is
⑤
reliable, fasten, not loosed.
d ismantle the screw
,
- -
6