Remote Starter Error Codes - CompuSTAR RS1B-DC3 Product Manual

REMOTE STARTER ERROR CODES:

NOTES
I WARNING: The following applies only when the parking
lights are connected and supported by the system.
II After a remote starter failure, the parking lights will fl ash
three [3x] times, then will fl ash [X] number times to
indicate an error code. See table.
REMOTE STARTER SHUTDOWN ERROR CODES:
NOTES
I WARNING: The following applies only when the parking
lights are connected and supported by the system.
II If the engine shuts down after a remote starter sequence:
Press and hold the Trunk button and the Start button at the
same time for 2.5 seconds when using a 1-WAY remote.
OR
Press once [1x] on button "4" when using a 2-WAY remote.
The parking lights will fl ash four [4x] times, then will fl ash
[Y] number times to indicate an error code. See table.
U.S. Patent No. 8,856,780
Automotive Data Solutions Inc. © 2017
REMOTE STARTER ERROR CODES - 1 OF 1
01 Engine running.
02 Key in ignition at ON position.
03 Door is open.
04 Trunk is open.
05 Foot brake is ON.
06 Hood is open.
07 The reservation is OFF. (Manual transmission only)
08 Tach failure.
09 The vehicle is moving (VSS).
10 System is in Valet Mode.
11 CAN communication failure
12 RS not synchronized. Start vehicle with OEM key for 15 sec before trying a new RS sequence.
13 Bypass problem.
01 Engine tach signal is lost.
02 Emergency brake is lost.
03 Foot brake is ON.
04 Hood is open.
05 Engine RPM limiter is ON.
06 Glow plug timeout error.
07 Vehicle is moving (VSS).
08 N/A
09 N/A
10 Door is open.
11 CAN communication failure during RS sequence.
12 RS not synchronized. Start vehicle with OEM key for 15 sec before trying a new RS sequence.
13 Takeover is not allowed.
14 Shutdown error, board overheat protection.
RS1B-DC3
PAGE 11 OF 12
• 20170829
www.idatalink.com