Gas cylinders are under very high pressure, follow these safety
instructions.
•
Gas cylinder contents are under high pressure.
•
Ensure contents of cylinders are properly identified.
•
Don't destroy or remove identification tags or labels.
•
Check to see cylinder valves are protected with protective caps.
•
Leave caps on until the gas is about to be used.
•
Do not roll or drop cylinders, or let them bump violently against each other.
•
Secure large cylinders (125 cuft) with a chain or strap positioned around the upper third of the
cylinder.
•
Small cylinders (22 cuft) may be put on their side and blocked to prevent from rolling.
•
Clear cylinder valve of any dust or dirt before attaching the regulator.
•
Some regulators are only for specific gases and regulators should not be interchanged. CGA580
valve connection must be used for argon and nitrogen cylinders.
•
Stand to the side of the regulator when opening the cylinder valve.
•
Open cylinder valve slowly.
•
Store cylinders in a well‐ventilated area away from all sources of heat or flames.
•
Before returning cylinder, close the valve and replace the protective cap.
•
Mark empty cylinders "EMPTY".
GAS CYLINDER SAFE HANDLING