Download Print this page

EL -KT100G-17 Instruction Manual page 3

Cordless illuminated glass kettle power: 220~240v 50/60hz 1850~2200w 1.7l

Advertisement

ALWAYS:
SPECIAL INSTRUCTIONS:
The Kettle has a short cord to reduce the hazards ofbecoming
entangled in or tripping over a longer cord.
Anextension cord may be used if the rating is equal to orgreater
than the rating of the Kettle. Use an extension cordrated 13
amperes or greater. Care must be taken to arrangeextension
cord so that it will not drape over countertop ortabletop where
it can be pulled on by children or trippedover unintentionally.
02
Before using this product, read and familiarize yourself with all
instructions.
Retain instructions for future reference.
Make sure that the voltage indicted on the product corresponds
to that of your local standard before connecting to the main
power supply.
Ensure that the lead cord grip is fastened correctly.
Unplug after use, before cleaning or while under repair.
Consult a qualified electrician to carry out any repairs or
To reduce risk of personal injury and damage to your iron
maintenance.
Supervise children and pets in the vicinity when using electrical
products.
Store electrical products in a dry place where they cannot be
damages by water or damp conditions.
NEVER:
Overload sockets and try to avoid the use of extension leads
or adaptors.
Allow children to operate electrical products.
Pull the cord to unplug the device from electrical outlets as
this will damage the cords wire and insulation.
Use if the product shows signs of being faulty. Unplug at once
if you smell burning, observe smoke or suspect any other fault.
If in any doubt as to the safety of the product, consult a
qualified electrician.
Use if the lead or plug shows any sign of damage, or it has
frayed or bare wires, loose connections.
Plug into a broken or cracked socket.
Place on a wet surface or handle electrical products with wet
hands.
Operating the Kettle and another appliance at the sametime
from the same electrical circuit could cause anelectrical
overload condition, which would blow the fuseor trip the
circuit breaker.

Advertisement

loading