ProForm 831.294230 User Manual page 8

5. Attach the end of the ground wire to the small hole in the
side of the Right Handrail (72) with a Silver Ground
Screw (75).
6. Loosen the two Crossbar Screws (39) two turns (one
Screw is shown). Place the Console Base (47) on the
Right Handrail (72) and the Left Handrail (not shown).
Attach the Console Base with four 3/4" Screws (2) (only
two Screws are shown).
Insert the Wire Harness (42) through the two indicated
plastic ties on the Console Base (47). Next, touch the
Right Handrail (72) to discharge any static. See the
inset drawing. Find the 5-pin connector on the end of the
Wire Harness. Insert the connector into the red socket be-
neath the console. The connector should slide easily
into the socket and snap into place. If the connector
does not slide easily and snap into place, turn the connec-
tor and then insert it. Insert the 6-pin connector into the
black socket beneath the console in the same way.
Make sure that the connectors and wires appear as
shown in the inset drawing. IF THE CONNECTORS ARE
NOT INSERTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON.
7. Insert the excess Wire Harness (42) into the large hole in
the side of the Right Handrail (72).
plastic ties on the bottom of the Console Base (47) to
prevent the Wire Harness from slipping. Then, cut off
the ends of the plastic ties.
Route the Wire Harness (42) through the indicated open-
ing in the Console Base (47). Attach the Wire Cover to the
Console Base (47) with a 1/2" Silver Screw (48). Note: Do
not overtighten the 1/2" Silver Screw.
Attach the Console Base (47) to the Crossbar (40) with two
3/4" Screws (2). Tighten the two Crossbar Screws (39)
(one Screw is shown).
Do not overtighten the Screws.
Securely tighten the
5
6
47
Ties
2
39
7
Ties
72
39
8
Ground
Wire
75
72
42
43
72
42
5-pin
47
Opening
42
44
40
48
2
6-pin