System BIOS
Restoring the Flash BIOS
To restore a corrupted Flash BIOS, a Crisis Recovery diskette is
required.
To restore the Flash BIOS:
1. Turn the computer Off by pressing [fn] +
Standby/Resume button.
2. Make sure the Diskette Drive Module is installed in the
computer.
3. Enable Crisis Recovery mode by placing a jumper
across resistor R744. This resistor is located in the
expansion memory compartment on the bottom of the
unit. To locate the resistor:
a) Place the unit in front of you with
the bottom up and the battery
closest to you.
b) Remove the cover on the memory
compartment.
c) The resistor is located in the lower
left corner of the memory
compartment.
4. Place the Crisis Recovery disk in the drive.
5. Turn On the system. When the BIOS is restored, turn
Off the system by pressing [fn] + Suspend/Resume
button.
Remove the jumper across resistor R744.
3-18