Table of Contents
Advertisement
1.
Insert the DIGITAL HiNote System CD into the CD-
ROM tray. The CD should boot to the A:\ prompt. At
the A:\, type:
PHDISKF /create 86016
There needs to be a space between the words
"PHDISKF" and "/create"
and a space between "/create" and "86016".
2. Press <Enter>.
86016 represents the size of the DOS file to be create in KBytes.
The equation for determining the DOS file size is 1024 (80 MB +
4 MB). 1024 is the number of KBytes per MegaByte. 80 MB is
the maximum amount of system memory and the additional 4
MB is for overhead.
Before you can load the Microsoft Operating System onto the
hard drive, you must first load the CD-ROM driver from the
DIGITAL HiNote System CD to the hard drive. It is located in the
Driver directory.
System Installation
If you want to remove all files from the hard drive and re-install
Windows Operating System but NOT remove the hard drive
partitions, please perform the following.
1. Insert the DIGITAL HiNote System CD into the CD-
ROM drive and power on the system.
2. Run format and then PHDISKF. Please refer to the
appropriate sections of this chapter.
3. Remove the DIGITAL HiNote System CD and power off
the notebook.
4. Insert the bootable floppy into the floppy drive and turn
on the system.
System Restoration
2-17
Advertisement
Table of Contents
