References To Illustrations - Miele SKCE0 Operating Instructions Manual

References to illustrations

The illustrations referred to in the text
are shown on the fold-out pages at
the end of these Operating Instruc-
tions.
Electrobrush operating instruc-
tions
Your vacuum cleaner is equipped with
an Electrobrush as standard. Please
read the separate operating instructions
supplied with the Electrobrush before
using it for the first time.
Preparing for use
Attaching the suction hose (Fig. 01)
 Insert the hose connector into the
suction socket on the vacuum
cleaner until it clicks into position.
Disconnecting the suction hose
(Fig. 02)
 Press the release buttons at the side
of the hose connector, and lift the
hose from the socket.
Connect the Comfort handle to the
telescopic wand (Fig. 03)
 Insert the Comfort handle into the
telescopic wand until it clicks into po-
sition.
 Press the release button to separate
the individual sections from each
other.
Adjusting the telescopic wand
(Fig. 04)
One part of the telescopic wand is fitted
inside the other so that the tube can be
adjusted to suit your preferred height
for comfortable vacuuming, the maxi-
mum height, however, is until the end
stop.
 Press the release button and adjust
the telescopic wand to the desired
height.
Connecting the telescopic wand to
the Electrobrush (Fig. 05)
 Insert the telescopic wand into the
Electrobrush until it clicks into posi-
tion.
Using the Electrobrush
Please observe the flooring manu-
facturer's cleaning and care instruc-
tions.
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following Electrobrushes.
– Electrobrush SEB 217
– Electrobrush SEB 228
– Electrobrush SEB 236
The Electrobrush is particularly suitable
for the intensive vacuuming of carpets
which are subject to hard wear.

Please note that the Electrobrush
should not be used to vacuum deep-
pile rugs and carpets or valuable
hand-knotted rugs and carpets, e.g.,
Persian and oriental rugs, etc. or long
piled rugs and carpets. There is a
risk of the threads being pulled out.
en-US
13