Power Source - Electrohome DVRC802E User Manual

Parts and functions
Inserting Batteries into the Remote Control:
1
Open the battery compartment
cover in the direction of the ar-
row.
Battery precautions
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the "–" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
Remote control basics
• Press POWER to turn the DVD/VCR on or off.
• Press CH or CH
• The / / / are also used to navigate on-screen menu system.
• You can directly access specific channels using numeric keys.
• Each press of DVD/VCR, switches the screen between the DVD screen (DVD mode) and the VCR screen (VCR
mode).
Operation
• Aim the remote control at the remote sensor and press control buttons to op-
erate.
• Operate the remote control within 30° angle on either side of the remote sen-
sor, up to a distance of approximately 5 meters (15 feet).

Power Source

AC Outlet
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other.)
2H6P001A[E] P12-21
2
Install two "AAA" batteries (not
supplied), paying attention to the
polarity diagram in the battery
compartment.
to move through the channels one channel at a time.
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC
cord plug into a standard 120V 60Hz polarized AC outlet.
NOTES:
• Never connect the AC line cord plug to other than the specified voltage
(120V 60Hz). Use the attached power cord only.
• If the polarized AC cord does not fit into a non-polarized AC outlet, do not
attempt to file or cut the blade. It is the user's responsibility to have an
electrician replace the obsolete outlet.
• If you cause a static discharge when touching the unit and the unit fails to
function, simply unplug the unit from the AC outlet and plug it back in. The
unit should return to normal operation.
15
3
Replace the compartment cover.
Approx.5 meters (15 feet)
30°
30°
6/28/05, 5:34 PM
15