Table of Contents
Advertisement
WARNING!
When installation is
complete, make sure that
the seal of each pipe fitting
does not leak. To check the
seal use a soap solution, not
a flame.
The gas supply ramp is on the rear side
of the control panel.
WARNING!
Before you connect the gas,
disconnect the appliance
from the electricity supply or
switch off the fuse in the
fuse box. Close the primary
valve of the gas supply.
14.8 Adjusting the minimum
gas level on the hob burner
1. Disconnect the appliance from the
electricity.
2. Remove the knob for the hob. If there
is no access to the bypass screw
dismount the control panel before
adjustment start.
3. With a thin and flat screwdriver adjust
the bypass screw A.
The model determines the position of
the bypass screw A.
A
A
14.9 Levelling
CAUTION!
Remove all the accessories
from the oven.
1. Open the lid of the appliance and
disassemble it.
2. Disassemble the pan supports and
all the burner assemblies.
3. Put the appliance on the sidewall on
a clean and smooth surface. Place
each foot into a separate hole, in the
plinth, and rotate it clockwise.
4. If the floor is not equally flat, use the
adjustable feet on the bottom of the
appliance to set a stable position for
the appliance.
ENGLISH
27
B
Advertisement
Table of Contents
