Maintenance - Blizzard 760HD Installation Instructions & Owner's Manual

Maintenance

Check fasteners for tightness. Torque to specifi cations.
Check hoses for wear and leaks.
Check cylinders for leaks, inspect rod ends for corrosion and pitting.
Lubricate all exposed cylinder rod ends with liquid white lithium grease to prevent
corrosion.
Check cutting edges and plow shoes for wear. NOTE: Do not discard plow shoe
washers, these should be retained for different shoe adjustments.
Clean and lubricate all electrical plugs and connections with dielectric grease. Clean
and install all dust caps prior to storing.
Lubricate all pins and bushings, and A-frame latch with NLGI Grade 2 multi-purpose
lithium complex grease with molybdenum (MPGM) to maintain consistent operation.
Clean and paint all scratches or exposed metal with BLIZZARD
Check the hydraulic fl uid level. Fill with fl uid to 3/4" from the top of the reservoir. Do not
exceed this level. Never mix different types of fl uid.
Remove and properly discard the fl uid from the pump reservoir. Clean the pump fi lter
and replace the hydraulic fl uid to within 3/4" from the top of the reservoir. Changing the
fl uid annually will prolong the life of your pump and manifold. Never mix different types
of hydraulic fl uid.
Check the trip spring adjustment. Properly adjusted tension will allow a sheet of paper to
pass between the 3rd and 4th coils of the spring.
Clean snow and ice build-up from the pump and manifold cover.
Pressure wash and dry the entire snowplow prior to storing.
Cover the snowplow with a tarp if stored outside. This will protect your snowplow from
sun fading and inclement weather which can lead to accelerated corrosion.
REMOVING FROM STORAGE
1. Perform all regular maintenance.
2. Replace the hydraulic fl uid in the pump reservoir.
Prolonged storage could result in condensation
build-up.
3. Follow the mounting procedure on the
POWER HITCH™ label.
4. Initiate all of the functions. Monitor the fl uid level
in the reservoir and fi ll to 3/4" from the top of the
tank as necessary.
5. Adjust the snowplow headlamps as needed.
Lit. No. B64090, Rev. 07
MAINTENANCE
touch-up paint.
®
LIFTING
To lift and move this snowplow, attach chain fall grab
hooks to outside pivot beam area shown. Always
follow recommended lift warnings and procedures.
See following page for snowplow weights and
dimensions.
34
Periodically Yearly
X
X
X
X
X
X X
X X
X X
X
X
X
X
X
X
Lifting Points
(both sides)
June 15, 2010