ProForm CrossWalk 495 LS User Manual page 8

CONSOLE DIAGRAM
_O_Vl
V'SUi"/'O_
se_, n-_v
A WARN|
r_dmq
_bbob_mt
_mdm_
KJep _ m
POWER INCLINE
ONI REEET
©
SPEED CONTROL
SPEEDTRAININGZONES
Note: If there is a thin sheet of clear
plastic on the console, remove it.
Key
BaRedes
Tab
BATrERY INSTALLATION
The console requires two or three "AA" batteries
(not included). Alkaline batteries are recommended.
Open the battery cover as shown in the drawing at the
upper right. Insert the batteries into the battery com-
partment, making sure that the negative (-) ends of the
batteries are touching the springs in the battery com-
partment.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
Inset drawing. Make sure that the tab locks Into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is propedy plugged in (see page 7).
Stand on the foot rails of the treadmill. Find the clip at-
tached to the key (see the drawing at the top of this
page), and slide the clip onto the waistband of your
clothes. Next, insert the key into the console. Test the
clip by carefully taking a few steps backward until
the key is pulled from the console. If the key is not
pulled from the console, adjust the position of the
clip as needed.
8