Using Ac Power; Using Vehicle Battery Power - Radio Shack PRO-528 Owner's Manual

Ni-Cd battery's useful life, it must be recycled
or disposed of properly. Contact
your local, county, or state hazardous
waste management authorities for information
on recycling or disposal programs
in your area or call 1-800-822-8837. Some
options that might be available are: municipal curbside
collection, drop-off boxes at retailers such as your local
RadioShack store, recycling collection centers, and mailback
.
programs
(If you need the "Important" on NiMH, please revise this sentence)

USING AC POWER

You can power the scanner using an 9V, 300 mA AC adapter and a size C Adaptaplug
supplied). Both are available at your local RadioShack store.
Cautions:
You must use a Class 2 power source that
supplies 9V DC and delivers at least 300
mA. Its center tip must be set to negative
and its plug must fit the scanner's
jack. Using an adapter that does not meet these specifications
could damage the scanner or the adapter.
• Always connect the AC adapter to the scanner before you connect it to AC power. When you finish,
disconnect the adapter from AC power before you disconnect it from the scanner.
Follow these steps to use the scanner on AC power.
1. Turn
VOLUME/OFF
2. Insert the Adaptaplug into the AC adapter's cord so it reads TIP –. Insert the Adaptaplug into the
scanner's
POWER 9V 300ｍA
3. Plug the AC adapter into a standard AC outlet.
If rechargeable batteries are installed and
the scanner and recharges the installed batteries at the same time. If the installed batteries are inappropriate,
the scanner stops the charging and displays
batteries.
Note: This is a rare case but scanner displays
appropriate.
If the scanner displays

USING VEHICLE BATTERY POWER

You can power the scanner from a vehicle's 12V power source (such as cigarette-lighter socket) using a 9V,
300 mA DC adapter and a size C Adaptaplug (neither supplied). Both are available at your local RadioShack
counterclockwise until it clicks to make sure the power is turned off.
jack.
ALKALINE
ERR CHArg. If you see the message, do not use the
ERR CHArg although the installed batteries are
ERR CHArg
DC 9V 300mA
is set to
JACK NI-MH
, please try to charge several times.
adapter (neither
™
, the adapter powers
NI-MH