Mobility
Anti-theft wheel bolts
Fig. 232
Anti-theft wheel bolt with wheel bolt cap and
adapter
To release the anti-theft wheel bolts, you need a
special adapter (provided in the vehicle's tool
kit).
� Pull off the hubcap* or wheel bolt
�Fig. 232.
� Slide the
adapter@
all the way onto the anti
theft wheel bolt®·
� Fit the box spanner (provided in the vehicle's
tool kit) as far as it will go over the adapter@.
� Loosen the wheel bolt �page 262.
{(!)
Note
Note the code number of the anti-theft wheel
bolt and keep it in a safe place - not in your
vehicle. If you need a replacement adapter,
give the code number to your Audi dealer.
Loosening the wheel bolts
Fig. 233
Changing a wheel: Loosening the wheel bolts
l l An adapter is required to unscrew or tighten the anti-theft
page
wheel bolts �
262.
262
� Fit the box spanner (provided in the vehicle's
tool kit) as far as it will go over the wheel
bolt 1 ).
0
,-..
st
0
� Turn the wheel bolt approx. one turn anti
st
CD
clockwise -arrow-. To apply the necessary tor
que, hold the box spanner near the end. If the
wheel bolt is very tight, you may be able to
loosen it by pushing down the end of the span
ner carefully with your foot. Hold on to the car
for support and take care not to slip.
A
To avoid accidents, the wheel bolts should on
ly be loosened slightly (one turn) before rais
ing the vehicle with the jack*.
Raising the vehicle
cap*@
Applies to: vehicles with jack
Fig. 235
� Always provide a firm base for the jack* on the
ground. (The jack can be found in the vehicle's
tool kit). If necessary use a large, strong board
or similar support. On a hard, slippery surface
WARNING
Sills: markings (example)
Door sill: Applying the jack under the door sill
..,_