Setting Up - Audi TTS Coupe 2015 Owner's Manual

Telephone

Setting up

Connecting a mobile phone via Bluetooth
Applies to: vehicles with telephone
Fig. 131 PIN display for entry on mobile phone
Important
The vehicle must be stationary, and the ignition
must be switched on.
The Bluetooth function and the discoverability
option of the MMI system Qpage
mobile phone must be activated.
The mobile phone you would like to connect must
not be connected actively to any other Bluetooth
device.
The MMI must not be connected to a mobile
phone.
Connecting a mobile phone
I
MENU I button
... Select:
mobile phone> Continue. The available Blue­
tooth devices will be shown on the infotain­
ment display. Or: Search for the MMI system
via the Bluetooth device search function on
your mobile phone.
... Select and confirm the desired mobile phone
from the list of Bluetooth devices shown.
... The MMI will generate a PIN for the connection
Qfig. 131.
... Select and confirm Yes.
... Enter the PIN to establish a connection on your
mobile phone. Or: If the PIN is already being
displayed on your mobile phone, confirm it on
the phone and on the MMI. You have about 30
seconds to enter the PIN.
l l Not available in all markets. Applies to mobile phones
with Bluetooth remote SIM Access Profile on vehicles with
Audi connect* and Audi phone box*.
132
204 and the
>Telephone> Connect
If you wish to connect your mobile phone via the
remote SIM Access Profile, please also enter your
SIM card's PIN in the MMI
Please note any additional system queries on
your mobile phone, e.g. whether the phone
should connect automatically in the future. On
some mobile phones, you may also need to
download the directory and allow access to your
messages separately.
After connecting successfully
After the connection has been established suc­
cessfully, you will be shown a short message con­
taining information on the profiles used to estab­
lish the connection. You can make changes to the
I
MENU I>
profiles via Settings> left control but­
ton> MMI settings> Connection manager
204. This can also be done at a later
page
Q
time.
In addition, the contacts on the mobile phone are
automatically loaded into the directory of the
MMI. This may take several minutes, depending
on how many contacts are stored on the mobile
phone.
You can configure your vehicle's mobile Wi-Fi
hotspot 1 > and the Audi connect services*
Qpage 146 immediately after connecting an
rSAP-enabled mobile phone.
ton> right control button>
> right control button >
ijJ)
Note
- You can adjust further settings for connec­
ted mobile phones using the connection
203 .
manager Qpage
- Bluetooth devices only have to be bonded
once. Any devices that have already been
bonded to the MMI system are connected
automatically when they are within range
and the ignition is on.
- You will need to authorise the MMI connec­
tion on your mobile phone to enable auto­
matic connection.
1 >.
Or: Select !T E L[ but­
Connection manager
Wi-Fi settings.