Connecting Network Devices - Cisco SG350X-24P Quick Start Manual

To install the switch into a 19-inch standard chassis:
Place one of the supplied brackets on the side of the switch so that
S 1
TEP
the four holes of the brackets align to the screw holes, and then use
the four supplied screws to secure it.
Repeat the previous step to attach the other bracket to the opposite
S 2
TEP
side of the switch.
After the brackets are securely attached, the switch is now ready
S 3
TEP
to be installed into a standard 19-inch rack.

Connecting Network Devices

3
To connect the switch to the network:
Connect an Ethernet cable to the Ethernet port of a computer,
S 1
TEP
printer, network storage, or other network devices.
Connect the other end of the Ethernet cable to one of the
S 2
TEP
numbered Ethernet ports of the switch.
The Ethernet port light turns green when the connection is active.
Refer to
different ports and LEDs on each switch.
4
Cisco 350X Series Switch Features for details about the
Cisco 350X Series Managed Switches