Adjustments - ProForm Recoil PFCCSY2926.1 User Manual

ADJUSTMENTS

This section explains how to adjust the resistance system. See the EXERCISE GUIDELINES on page 16 for
important information about how to get the most benefit from your exercise program. Also, refer to the accompa-
nying exercise guide to see the correct form for each exercise.
Make sure all parts are properly tightened each time the resistance system is used. Replace any worn parts
immediately. The resistance system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do
not use solvents.
ADJUSTING THE SEAT
To use the Seat (31), first hold the Seat Frame (8) at
a declined angle and set the bracket onto a bar on
the Upright Base (5). Then, pivot the Seat Frame
down.
To remove the Seat (31), first make sure that the Short
Cable (not shown) is not attached to the Leg Lever
(9). Then, lift the Seat Frame (8) off the Upright Base
(5). Store the Seat away from the resistance system
while performing an exercise that does not require it.
ADJUSTING THE RESISTANCE
To add resistance, hold a "U"-channel (18) firmly and
push the end of a resistance bar under it. Repeat with
the other end of the resistance bar. If more resistance
is needed, add one resistance bar at a time.
Note: When adding resistance, always start with the
heaviest resistance bar to be used, and finish with the
lightest resistance bar. When removing resistance
bars from the "U"-channels (18), start with the lightest
resistance bar and finish with the heaviest.
WARNING:
ance, make sure that both ends of the resist-
ance bar rest under the two "U"-channels (18).
Do not add or remove resistance bars from
the "U"-channels while an end of the Long
Cable (42) is pulled out.
Note: The resistance system uses progressive resist-
ance. As the resistance bars begin to bend, the
amount of resistance will increase gradually. As the
resistance bars bend further, the resistance will
increase rapidly.
Additional resistance can be added to the resist-
ance system. To purchase more resistance, call the
toll-free telephone number on the front cover of this
manual and ask for model number PFMC0825 (100-
pound Max Pack).
When adding resist-
31
8
9
18
13
Bracket
5
Resistance
Bars
42
18