Acura NSX 2018 Owner's Manual page 97

MAINTENANCE
TABLE OF
CONTENTS
Changing Wiper Blades
If the wiper blades leave streaks across the windshield, try cleaning them first with a paper towel
or soft cloth and wiper fluid. If the wiper blade rubber has deteriorated, you should change the
VISUAL INDEX
wiper blades.
1. Hold the wiper switch in the MIST position as you change the
power mode to VEHICLE OFF. The wiper arms will move into
SAFETY
the service position.
INFORMATION
INSTRUMENT
PANEL
2. Lift both wiper arms.
VEHICLE
CONTROLS
AUDIO AND 3. For each wiper, press and hold the tab, then slide the wiper
CONNECTIVITY
blade holder out from the wiper arm.
BLUETOOTH®
HANDSFREELINK®
ACURALINK®
186 |
4. Pull the end of the wiper blade (in the direction of the arrow
in the image) until it is out of the holder's end cap.
5. Pull the wiper blade in the opposite direction to slide it out of
its holder. Insert the flat side of the new wiper blade onto the
bottom part of the holder. Insert the blade all the way and
install the end cap.
6. Slide the wiper blade onto the wiper arm until it locks and
lower both wiper arms.
7. Set the power mode to ON. Hold the wiper switch in the
MIST position until the wiper arms return to their normal
position.
NOTICE
Avoid dropping the wiper arm, as it may damage the windshield.
Tab
MAINTENANCE
NAVIGATION
Wiper
Blade
DRIVING
End Cap at
the bottom
HANDLING THE
UNEXPECTED
MAINTENANCE
Holder
SPECIFICATIONS
CLIENT
INFORMATION
VOICE
COMMAND
INDEX
INDEX
| 187