Starting Fluids (Flammable Liquids) - Dodge RAM 1500 2018 Diesel Supplement

NOTE:
• Engine idle speed will automatically increase to 1,000 RPM
and engage the Variable Geometry Turbocharger at low
coolant temperatures to improve engine warm-up.
• When a diesel engine is allowed to run out of fuel or the
fuel gels at low temperatures, air is pulled into the fuel
system. If your engine has run out of fuel, refer to
"Maintenance Procedures/Priming If The Engine Has
Run Out Of Fuel" in "Servicing And Maintenance" for
further information.
• If the engine stalls, or if the ignition switch is left ON for
more than two minutes after the "Wait To Start" telltale
goes out, reset the grid heaters by turning the ignition
switch to the OFF position for at least five seconds and
then back ON. Repeat steps 1 through 5 of "Starting
Procedure – Engine Manifold Air Temperature Below
66°F (19°C)."
Starting Fluids
WARNING!
Starting fluids or flammable liquids must never be
used in the Cummins diesel engine (see Warning
label). Never pour diesel fuel, flammable liquid, start-
ing fluids (ether) into the air cleaner canister, air intake
piping, or turbocharger inlet in an attempt to start the
vehicle. This could result in a flash fire and explosion
causing serious personal injury and engine damage.
The engine is equipped with an automatic electric air
preheating system. If the instructions in this manual are
followed, the engine should start in all conditions.
WARNING!
• Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build up may
cause serious injury or death.
• When leaving the vehicle, always make sure the
keyless ignition node is in the "OFF" mode, remove
the key fob from the vehicle and lock the vehicle.
STARTING AND OPERATING 125
(Continued)
4