ProForm PFSY92080 User Manual page 14

31. Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35)
in the direction shown. Slide the Pulley and a Cable
Trap (44) onto a 3/8Ó x 4 3/4Ó Bolt (65). Slide the Bolt
into the indicated hole in the bracket on the Butterfly
Upright (2). Thread a 3/8Ó Nylon Locknut (50) a cou-
ple of turns onto the Bolt to prevent it from sliding out
during the following steps.
32. Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35)
in the direction shown.
Attach the Pulley (35) and a Cable Trap (44) to the
lowest of the two holes in the Pulley Plates (31) hang-
ing from the High Cable (73). Secure the Pulley and
Cable Trap with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon
Locknut (50).
Make sure the Cable Trap is oriented as shown
and that it is mounted between the Pulley Plates.
33. Remove the 3/8Ó Nylon Locknut (50) that was thread-
ed onto the 3/8Ó x 4 3/4Ó Bolt (65) in step 31.
Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35)
in the direction shown. Slide the Pulley and a Cable
Trap (44) onto the 3/8Ó x 4 3/4Ó Bolt (65). Secure the
Pulley with a 3/8Ó Nylon Locknut (50).
Make sure both Cable Traps attached to the 3/8Ó x
4 3/4Ó Bolt (65) are oriented as shown in this step
and in step 31.
34. Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35)
in the direction shown. Attach the Pulley and a Cable
Trap (44) to the ÒIÓ-plates (31) hanging from the Short
Cable (97). Secure the Pulley and Cable Trap with a
3/8Ó x 2Ò Bolt (62) and a 3/8Ó Nylon Locknut (50).
Make sure the Cable Trap is oriented as shown
and that it is mounted between the Pulley Plates.
31
50
32
31
50
44
72
33
72
50
35
34
50
44
14
72
35
44
2
73
62
35
2
44 65
97
31
62
35
72
65