D-Link Air DWL-120 Manual page 14

Using the Configuration Utility
Configuration
Network Type:
Infrastructure is the factory default setting. Ad-Hoc mode is used for peer
to peer networking. See the Getting Started section in this manual for
examples of these network types.
SSID:
The Service Set Identifier is the name assigned to the wireless network. The
factory SSID setting is set to default. Make changes here to match the
SSID on existing Wireless Router or Access Point.
Tx Rate:
You can adjust the transmission rate to get the best signal possible depend-
ing on your usage and your environment.
Default Setting:
Reverts the DWL-120 back to its factory default settings
WEP Setting:
Will allow you to configure the Encryption for your DWL-120. By default
WEP is disabled.
Advanced Setting:
To configure advanced settings for Power, RTS and Fragmentation Threshold.
14