Removing And Mounting The Front Wheel - KTM 2001 50 SX Pro Senior LC Owner's Handbook Manual

1
2
4

Removing and mounting the front wheel

Jack up the motorcycle by the frame.
Remove the right hexagon nut of the wheel spindle
washer.
Pull the wheel spindle halfway out and remove the spacer
Now pull out the wheel spindle out until the wheel is free but not so far that
the brake backing plate comes off.
Turn both wheel and fork slider tube to the left and remove wheel.
To mount the wheel reverse the procedure described above.
Tighten the hexagon nut with 30 Nm (22 ft.lb).
Removing and mounting the rear wheel
Jack up the motorcycle by the frame.
Remove the right hexagon nut of the wheel spindle
3
washer.
Hold the rear wheel and remove the wheel spindle.
Move the rear wheel downward, remove the chain and take the rear wheel
out of the swing arm.
To mount the wheel reverse the procedure described above.
Always hook the brake backing plate into the swing arm support.
Before tightening the hexagon nut of the wheel spindle, ensure that the
supporting plates
that the rear wheel is aligned with the front wheel.
4 Tighten the hexagon nut with 30 Nm (22 ft.lb).
Tires, air pressure
Tire type, tire condition, and air pressure level affect the way your motorcy-
cle rides, and they must therefore be checked whenever you are getting
ready to go anywhere on your motorcycle.
– Tire size can be found in the technical specifications.
– Tire condition has to be checked every time you want to ride your
motorcycle. Before leaving, check tires for punctures and nails or other
sharp objects that might have become embedded in them.
– Regularly check the "cold" tire pressure. Correct tire pressure (1.0 bar /
14 psi) guarantees optimum grip and maximum tire life.
– D
AMAGED TIRES MUST BE REPLACED IMMEDIATELY TO PROTECT YOUR YOUNGSTER
– W
ORN TIRES CAN HAVE A NEGATIVE EFFECT ON HOW THE MOTORCYCLE PERFORMS
ESPECIALLY ON WET SURFACES
– T
IRE PRESSURE BELOW THE NORMAL LEVEL WILL LEAD TO PREMATURE TIRE WEAR
Checking spoke tension
The correct spoke tension is very important for the stability of the wheels
and thus for riding safety. A loose spoke causes the wheel to become
unbalanced and before long other spokes will have come loose. Check
spoke tension, especially on a new motorcycle, in regular intervals. If neces-
sary, have the spokes retightened and the wheel centered by a KTM dealer.
S
POKES CAN TEAR IF YOU CONTINUE TO RIDE WITH THEM LOOSE
UNSTABLE HANDLING OF YOUR MOTORCYCLE
4
are resting against the swing arm. Additionally, check
WARNING
WARNING
.
1
together with the
2
.
3
together with the
15
.
,
.
. T
HIS MAY LEAD TO AN