Summary of Contents for Galmet Easy Air Basic 2 GT
Page 1
Operation & Installation Manual WARRANTY CARD EASY AIR BASIC 2 GT Air-To-Water Heat Pump In operating mode the heat pump generates domestic hot water at a maximum temperature of 50ºC - 1 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.” Sp.K.
Page 2
17. Device inspection card ....................... 15 18. Declaration of Conformity ....................15 19. Notes ........................... 17 20. Warranty Terms and Conditions ..................18 21. Warranty card ........................19 - 2 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
1. Use and operation The EASY AIR BASIC 2 GT heat pump is an air-to-water heat pump making it possible to provide domestic hot water maximum for a 6-person family. The maximum temperature of the domestic hot water generated by the heat pump is 50°C. However, for energy-saving reasons it is recommended not to set the temperature of domestic hot water above 45 °C, as it will result in raising the costs of using the heat pump and will...
15ºC 4.5 h + 10ºC 15ºC 5.5 h 15ºC + 7ºC 6.0 h Coil Each heat pump is equipped with one coil used to connect additional heat sources. - 4 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
3. The device should be carried in its original packaging. 4. When lifting the device always use protectors to avoid damage to tapes and ensure the device weight is properly balanced. - 5 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
Coil return Cold water Fig. 6 Heat pump positioning inside the boiler room The minimum length between the suction duct and cold air outlet should be 1.5 m !! - 8 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
Domestic hot water room, garage Coil supply Circulation Sensor Coil return Cold water Fig. 8 Air supply from the boiler room and discharge into another room - 9 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
12. Schematic diagram of the heat pump hydraulic system Fig. 11 Schematic diagram of the heat pump hydraulic system 13. Connections Fig. 12 Heat pump connections - 11 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
14. Schematic diagram of the device hydraulic system Fig. 13 Schematic diagram of the heat pump - 12 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
The heat pump should be provided with a current-differential and overcurrent protections (fuses); the rate of overcurrent protections depending on the device electrical power is presented in the table below. Protection Type Heat Pump Type EasyAir Basic 2GT - 13 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
Page 14
A proper recycling of electrical and electronic devices helps to protect the natural environment and prevents negative impact on human health. - 14 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
Pressure in Servicing Stamp and heating circuit operations signature of fitter First start-up Inspection after 12 months Inspection after 24 months Inspection after 36 months 18. Declaration of Conformity - 15 - OPERATION MANUAL AND WARRANTY CARD "Galmet Sp. z o.o.”...
DECLARATION OF CONFORMITY "Galmet Sp. z o.o.” Sp. K. (Company name) UL. RACIBORSKA 36 48-100 GŁUBCZYCE declares that the following product: EasyAir Basic 2GT Air-To-Water Heat Pump this declaration applies to is compliant with the following Directives: - Pressure Equipment Directive (PED): 97/23/EC...
14. When the Buyer makes it impossible to carry out a warranty repair twice, despite the warrantor’s readiness to carry it out, it is considered that the Buyer gives up the warranty claim. "Galmet Sp. z o.o.” Sp. K., reserves the right to introduce changes in the specifications or models to improve devices without prior notice.