Page 1
Hanover Outdoor Furniture IMPORTANT If you have any problems with this product (missing or damaged parts, assembly issues, etc.), PLEASE DO NOT RETURN TO THE RETAILER/STORE from where you purchased the product. 1‐800‐416‐3511 Please call our Toll‐Free Customer Service Hotline at: Between 9:00 AM and 5:00 PM Eastern Time, Monday through Friday www.hanover‐products.com Or visit our website at: To expedite any future warranty claims, please retain the Instruction Sheet, Warranty Card and receipt for future use. For additional on‐line support on assembly, troubleshooting and care & maintenance of your outdoor furniture, please visit our website at: www.hanover‐products.com. 6/1/2015 (a) ...
Page 2
ASSEMBLY INSTRUCTIONS From behind the chaise lounge back frame, insert a bolt with Ø8.5x1.5 mm washer through the hole in the lower sling back frame. Add a Ø15x4 mm plastic washer before inserting into the fixed nut in side the sling seat frame (see diagram).
Page 3
Ø8.5 X 1.5 MM HW0005 WASHER HW0006 HEX BOLT DRIVER ADJUSTMENT BAR AL1586 FACTORY ASSEMBLY BUMPER HW0078 FACTORY ASSEMBLY SLING TUBE CAP 1 FC0005 FACTORY ASSEMBLY SLING TUBE CAP-2 FC0468 FACTORY ASSEMBLY FOOT CAP FC0030 FACTORY ASSEMBLY ADL17002 Page 5...
Page 4
ASSEMBLY INSTRUCTIONS Fig 1 Attach a side panel to the legs by using the bolts and washers as shown in Guide the bolts through the holes in the side panel into the pre-drilled holes in the legs Hand tighten only. Repeat for the other side panel.
Page 5
ASSEMBLY INSTRUCTIONS Place the table top upside down on a flat, non-abrasive surface. Attach the table legs to the table top by using the Fig 3 . bolts and washers as shown in Guide these bolts through the holes in the legs, into the pre-drilled holes in the table top Use the hex bolt driver to tighten all bolts Do not over tighten .
Page 6
PARTS IDENTIFICATION LIST * NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE ORDER PART # QTY PARTS LIST DESCRIPTION TABLE TOP AT70658 TABLE LEG AT70659 AT70660 SIDE PANEL BOTTOM PANEL AT70661 UMBRELLA AT70662 BASE POLE HW0034 1/4" X 15 MM BOLT Ø6.5 X 1.0 MM HW0004 WASHER...