Flymo Turbo Lite 350 Manual page 7

3. Before using always visually inspect to see
that blades, blade bolts and cutter assembly
are not worn or damaged. Replace worn or
damaged blades together with their fixings in
sets to preserve balance.
Use
1. Use the lawnmower only in daylight or good
artificial light.
2. Avoid operating your lawnmower in wet grass,
where feasible.
3. Take care in wet grass, you may lose your
footing.
4. On slopes, be extra careful of your footing and
wear non-slip footwear.
5. Mow across the face of slopes, never up and
down.
6. Exercise extreme caution when changing
direction on slopes. Walk never run.
7. Mowing on banks and slopes can be
dangerous. Do not mow on banks or steep
slopes.
8. Do not walk backwards when mowing, you
could trip.
9. Never cut grass by pulling the mower towards
you.
10. Switch off before pushing the mower over
surfaces other than grass.
11. Never operate the lawnmower with damaged
guards or without guards in place.
12. Always start the lawnmower carefully with feet
well away from the blades.
13. Do not tilt lawnmower when the motor is
running, except when starting and stopping.
A1 - lower handle
A2 - slots
A3 - fixing pin
Fitting the Lower Handles to Your Lawnmower
(A)
1. Place the end of the lower handle into the
slots.
2. Secure lower handles to hood by firmly
pushing fixing pin through holes in hood and
handle.
3. Repeat on the other side.
• NOTE
Should a problem occur when securing handle
to hood with the fixing pin, carefully lever
fixing pin out of location and repeat steps 1 to
3 above.
SAFETY PRECAUTIONS
14. Never pick up or carry a mower when it is
15. Remove the plug from the mains :
-
-
-
-
-
Maintenance and storage
1.
2.
3.
4.
ASSEMBLY
B1 - lock off button
B2 - handle knob
B3 - washer
B4 - bolt
Fitting Upper Handles to Lower Handles (B)
1.
2.
3.
4.
In this case, do not tilt more than absolutely
necessary and lift only the part which is away
from the operator. Always ensure that both
hands are in the operating position before
returning the appliance to the ground.
operating or still connected to the mains
supply.
before leaving the mower unattended for any
period;
before clearing a blockage;
before checking, cleaning or working on the
appliance;
if you hit an object. Do not use your
lawnmower until you are sure that the entire
lawnmower is in a safe operating condition.;
if the lawnmower starts to vibrate abnormally.
Check immediately. Excessive vibration can
cause injury.
Keep all nuts, bolts and screws tight to be
sure the lawnmower is in safe working
condition.
Replace worn or damaged parts for safety.
Only use the replacement blade, blade bolt,
spacer and impeller specified for this product.
Be careful during adjustment of the
lawnmower to prevent entrapment of the
fingers between moving blades and fixed parts
of the machine.
Ensure the upper handle is located correctly
with the lock-off button on the switchbox
uppermost.
Ensure the upper handle and the lower handle
are aligned correctly.
Fit the bolts, washers and handle knobs.
Fit the cable to the handles with the clips
provided. Make sure the cable is not trapped
between the upper and lower handles.
ENGLISH - 2