Olympus SP-570UZ Advanced Manual page 24

#SLOW2 Slow
synchronization 2
• Flash options are disabled if the pop-up flash is closed.
a j button
Press j in shooting mode to select the drive mode.
Press o to confirm your selection.
o
Single-frame shooting
j
Sequential shooting
c High speed sequential
shooting 1
d High speed sequential
shooting 2
g Pre-capture
i AF sequential shooting
7 Bracket shooting
You can take a sequence of pictures at one time by holding down the shutter button. The camera
will take pictures continuously until you release the shutter button.
• The exposure differential and number of frames for bracket shooting can be set in [DRIVE] in the
[CAMERA MENU].
g "DRIVE Continuous shooting" (P.40)
b AF/MF switch
Slide the AF/MF switch in shooting mode to set the focus mode.
AF
MF
P
1m 1m 3m 3m 5m 5m
10 10
M M
F F 1/400 1/400 F3.5 F3.5
INE INE
24
EN
The flash fires just before the shutter closes (2nd curtain).
You can use this setting to create interesting effects in your
picture, such as expressing the movement of a car by
showing the tail-lights streaming backwards. The slower the
shutter speed, the more pronounced the effects.
Shoots 1 frame at a time when the shutter button is pressed.
Focus and exposure are locked at the first frame. The
sequential shooting speed varies depending on the image
quality setting.
Pictures can be taken at a faster speed than normal sequential
shooting.
Sequential shooting at a speed of approximately 13.5 frames/
sec.
Sequential shooting at a speed of approximately 13.5 frames/
sec. Pressing the shutter button halfway stores 10 frames of a
picture immediately before shooting.
Adjusts the focus 1 frame at a time. The shooting speed is
slower than for normal sequential shooting.
Takes pictures sequentially while changing the exposure for
each frame. Focus and white balance are locked at the first
frame.
Press the shutter button halfway. The camera automatically
focuses.
Adjust the focus manually.
When set to [MF]
• Press 4 3 to set the focus. During operation, the center of the
MF
frame is enlarged.
• Hold down o to fix the focus. The focus is locked at the
distance you have set, and MF is displayed in red on the
monitor. To adjust the focus, hold down o again.
• The distance displayed on the monitor is a reference figure.
• You can use the zoom ring or the control dial as well as 4 3 to
4 4
IN
adjust the focus.
g "MANUAL FOCUS Selecting the focusing method in manual
focus mode" (P.58)
Single-frame shooting/Sequential shooting
Changing the focus method