Table of Contents
Advertisement
Coaxial Cable & Continuity Testing:
To validate cable shield during cable map tests, do the following as
shown in Figure 9:
1.
Connect the Transmitter to the circuit as shown in
Figure 8. Connect the test leads to the coaxial cable to
be tested.
2.
Push "
LOW" indicator will light up. Push "
transmitter for short/ open function, the green LED
indicator lights up and the short/ open testing is
working. Push "
the product is standby for next operation.
3.
When "SHORT" red LED indicator lights up, the cable
is connected. (the resistance of cable is less than
300Ω). If the indicator is off, the cable is short or
resistance of the cable is over 300Ω .
DANGER ： Before testing, please be sure the power
of receiver is OFF.
" button to turn on the power, "POWER/ BAT
Testing for
continuity
OPEN
Open : Resistance
SHORT
Short : Resistance
Figure 9 Coaxial Cable & Continuity Test
" again, the green LED lights off and
Validating the
cable 's shield
No light
RED
19
" button on
Ω
push
Advertisement
Table of Contents
