Table of Contents
Advertisement
Locating Individual Wire Pairs with the MT-7028 Analog
Function
To locate cables, do the following steps (Figure 3)：
1.
Connect the black alligator clip of the Transmitter to the
ground, and then connect the red clip to a jack or
punch-down block as shown in Figure 3.
2.
As the Figure 3 shown, when push
"POWER/ BAT LOW" will light up and turn on the power.
Push
indicator flickered, the low-tone cable tracing is working.
Push
tracing, the RED indicator will flicker faster. Push
button again, the RED indicator will be stopped and
standby for next operation.
3.
AS the figure 3 shown, push "
cable tracing function. The tracing sound will be output
from speaker. When put on earphone, there will be no
sound from speaker, but from the earphone.
4.
Use the Receiver to find the general location of the tone at
a cable rack, patch panel, or behind a wall. In locating
mode, the Receiver's LEDs light up in red from 1 to 8, then
wrap back and light up from 1 to 8 again as the signal
strength increases.
5.
Adjust the Volume Control on the Receiver to locate the
wire pairs from 10cm to 30cm.
RJ11 J
ack
RJ45
Jack
Ground
SCAN
Double push:High
button for cable tracing. When the RED
button again to feature the high-tone cable
SCAN
SCAN
Volume control
Push:Low
Figure 3 Locating cables
" on receiver to operate
12
, the indicator of
SCAN
SCAN
Volume control
Advertisement
Table of Contents
