Download Print this page

Operating Procedures - BPM F-15 Assembly Instructions & Owner's Manual

Advertisement

SAFETY
Helmet:
Always wear an approved helmet while riding your Pedego and follow
the helmet manufacturer's instructions for it, use and care of your helmet.
It is your responsibility to familiarize yourself with the laws of where you
ride your Pedego and to comply with all applicable laws.
Mechanical Safety Check:
Check the condition of your Pedego before every ride. Make sure
no nuts, bolts or ixings are loose, with particular attention to the axle
nuts and handlebar stem. Make sure the tires are correctly inlated with
the recommended air pressure that is located on the side wall of every
tire. Check the brakes for proper operation.
You must take your bike in to be serviced and checked by a qualiied bike
mechanic before 100 miles (161 kilometers) of riding. This is a standard good
practice for any new bike as cables will stretch and components will 'bed in'.
The service must include spoke tensioning for both front and rear wheels.
Your First Ride:
When you buckle on your helmet and go for your irst ride, be sure
to pick an area away from cars, other cyclists, obstacles or other hazards
in order to become familiar with the controls, features and performance
of your new Pedego.
Additional Passengers:
The Pedego bikes are designed for one passenger only (excluding Tandems).
DO NOT carry any additional passengers on the front or rear of the bike.
The rear rack holding the battery is not designed to carry the weight
of any additional passengers, including baby carriers.
Weight Capacity:
Pedego Electric Bikes are designed with a maximum weight capacity of 250
pounds for all models. The rear rack maximum weight capacity of a Pedego
(if applicable) is 25 pounds. Exceeding the maximum weight capacity can
result in damage of the bike which can lead to serious injury.
12
Safety

OPERATING PROCEDURES

For Boomerang, Boomerang Plus, City Commuter
Comfort Cruiser, Interceptor, & Tandem
To be able to use the electric motor, the battery must be mounted by sliding
the fully charged battery forward into the battery holder.
Locked
The battery automatically locks into the bike when fully inserted in the
battery holder. The locking mechanism is spring loaded and unlocks when
the key is turned to the open position, allowing the battery to slide out. The
battery must be locked when riding or it may fall out. The key does not have
to be in to operate the bike.
On
The on/off switch is located on the bottom of battery. After fully inserting
the battery into place, turn the battery on by lipping the switch to the "|"
position. Be sure to turn off the power when the Pedego is not in use or
is recharging by clicking the battery switch to the off "O" position.
Open
Off
Operating Procedures
13

Advertisement

loading