Advertisement
ASSEMBLY INSTRUCTIONS
For Boomerang, Boomerang Plus,
Comfort Cruiser, Interceptor, & Tandem
Your bike has been pre-assembled and requires only a few simple steps
to get it ready for you to ride:
1. Remove the outside carton after cutting the nylon bands and lift off the
entire box from the tray at the bottom. Carefully remove your bike from the
bottom tray and gently rest it in place with the kickstand down.
2. Remove all of the inside cardboard protection and bubble wrap.
3. Please locate and set aside the kit box containing the battery charger,
pedals, and tool kit.
4. The handlebars must be adjusted for height and alignment. First,
remove the rubber protective cap and insert the handlebar stem into the
frame of the bicycle (Figures 1 & 2).
5. With the 6 mm allen wrench provided in the tool kit, tighten the screw
on top of the stem underneath the rubber protective cap to secure the
handlebars in place. Make sure the handlebars are aligned with the front
wheel before tightening and that the stem is not set above the maximum
height indicator.
Figure 1
6
Assembly Instructions
Figure 2
Figure 3
6. If need be, the angle of the handlebars may be positioned to your personal
preference. Loosen the front 2 bolts on the front stem plate and angle the han-
dlebars to your liking (Figure 3), then securely tighten the 2 bolts on the front
stem plate. Make sure that, when tightening, there is even spacing between
the top and bottom bolts to ensure maximum stability (Figure 4).
Continued on Page 12
Figure 4
Assembly Instructions
7
Advertisement
