F15 ASSEMBLY
1) Open box layout all the pieces also small box
2) Remove battery by pushing ignition key in and turning left. Notice pin now
clears hole in battery track near top.
Gently pull battery up by handle and prepare to charge.
3) Charge battery with charger.
a) plug in microphone style connector (XLR) into battery first,then AC house
current plug into house outlet.
4) Remove protective bubble wrap from bike.
a) Display meter on handle bars should be on the left side when you are sitting
on the bike.
b) make sure cables are straight and not twisted by turning handle bars if
necessary .
c) Insert shaft from handle bars by opening folding mechanism with lever.
d) Slide in shaft and lock in lever.
5) Flip bike so its resting upside down.
a) Begin assembling front fender (short end will be facing forward)
b) Remove bolt at upper fork area. Bend slotted metal at fender so it goes to
outer side of fork.
c) Insert bolt all the way thru and add head-light facing forward at the end of
bolt.
d) Tighten bolt but not too tight so you can adjust fender later from rubbing
against the tire.
6) Place front wheel onto front fork gently so disc also goes into front caliper.
Wiggle loose brake caliper so it better aligns with disc. Carefully tighten
brake caliper bolts while squeezing the front brake lever at the
same time. DO NOT OVER TIGHTEN CALIPER BOLTS !!!! If you do threads
can easily strip
7) QUICK RELEASE SHAFT : Remove one spring and plastic nut Slide in thin
quick release rod thru the middle of the front axle . Lever should be on
opposite side of disc.