Advertisement
ASSEMBLY INSTRUCTIONS
For Trail Tracker
Your bike has been pre-assembled and requires only a few simple steps
to get it ready for you to ride:
1. Remove the outside carton after cutting the nylon bands and lift
off the entire box from the tray at the bottom. Carefully remove your
bike from the bottom tray and gently rest it in place.
2. Remove all of the inside cardboard protection and bubble wrap.
3. Please locate and set aside the kit box containing the battery
charger, pedals, and tool kit.
4. Install the front wheel by aligning the brake and fork and
tightening the axle nuts with the 15 mm wrench provided with
your kit. Make sure that the hooked washers are on the outside
of the fork and are properly secured.
8
Assembly Instructions
5. If necessary, align the stem with the front wheel and tighten the
top stem bolt enough to hold the stem in place. Once the handlebars
are aligned and the top bolt is slightly secured, irmly tighten the 2 side
bolts on the stem. After tightening the 2 side bolts, irmly tighten the
top bolt. After all 3 bolts have been securely fastened, make sure there
is no play in the headset.
TOP BOLT
SIDE
BOLT
SIDE
BOLT
Figure 3
Be careful to not tighten the top bolt too much as the steering will feel rigid
and sluggish.
Continued on Page 12
Figure 4
Assembly Instructions
9
Advertisement
