GE IM4D Owner's Manual & Installation Instructions page 15

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
(Continued)
ATTACH THE WATER VALVE TO
4
THE MACHINE COMPARTMENT
connector plug. Plug the
female connector onto
the male terminals on
the water valve. Either
wire can go on either
terminal.
valve to the
cabinet by driving
the hex-head
the kit through
the hole in the
bracket extension
and into the hole
in the cabinet.
INSTALL WATER LINE CLAMP
5
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
water line clamp
kit to the refrigerator. With
the clamp directly in line
with the water valve, drive
the screw
through the clamp at the
indent into the back of the
cabinet.
not to be used for the tubing from the water
valve up to the icemaker.
49-60698-4
Installation Instructions
9
ELECTRIC SHOCK
HAZARD
5
ROUTE AND ATTACH THE
6
PLASTIC WATER LINE
cabinet with adhesive-backed fasteners
WATER VALVE INSTALLED
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
REINSTALL THE COVER
8
removed previously to reattach the cover to
the back of the refrigerator case. This must
be reinstalled for your refrigerator to function
6
properly.
4
Adhesive-backed
fastener for plastic
water line
15